This high-density steel, round disc cutter cuts and punches perfect circles in four sizes: 1” (25.4 mm), 1-1/4" (31.75 mm), 1-1/2" (38.1 mm), and 2" (50.8 mm). Cuts soft metals up to 18 gauge.
Instructions for use:
• Use a disc cutter on top of a rubber bench block or pad for support. Use a cutting lubricant, such as "Cut Lube" to lubricate the cutting edges of the punch. Use a suitable mallet, never a nail driving hammer. We suggest our 1 lb or 2 lb brass mallets.
• Always support the opposite side of the cutter with a sheet of the same diameter metal that you are cutting. (This will help keep the upper and lower parts of the disc cutter in alignment and help minimize material sticking in the disc cutter).
• Do not exceed the maximum thickness recommended for your disc cutter.
• Only cut soft non-ferrous metals like brass, copper, silver and gold.
• Make sure that your cutting edges are down.
• To prevent rust, keep your disc cutter well-lubricated between use and store in a dry location.
• We recommend to use this with a rubber bench block pad or red urethane pad for surface protection.
• Finish your blank by either drilling a hole for a chain or cord.
SKU | FORM-0018 |
---|---|
Price | $136.22 |
Controller | N/A |